PIC18F4539T-E/ML【PDF 270/322 页】IC PIC MCU FLASH 12KX16 44QFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3881

266页 267页 268页 269页 [270页]271页 272页 273页 274页

2002 Microchip Technology Inc.

Preliminary

DS30485A-page 49

PIC18FXX39

4.13

STATUS Register

The STATUS register, shown in Register 4-2, contains

the arithmetic status of the ALU. The STATUS register

can be the destination for any instruction, as with any

other register. If the STATUS register is the destination

for an instruction that affects the Z, DC, C, OV, or N bits,

then the write to these five bits is disabled. These bits

are set or cleared according to the device logic. There-

fore, the result of an instruction with the STATUS

For example, CLRF STATUS will clear the upper three

bits and set the Z bit. This leaves the STATUS register

as 000u u1uu (where u = unchanged).

It is recommended, therefore, that only BCF, BSF,

SWAPF,

MOVFF

and MOVWF instructions are used to

alter the STATUS register, because these instructions

do not affect the Z, C, DC, OV, or N bits from the

STATUS register. For other instructions not affecting

any status bits, see Table 21-2.

REGISTER 4-2:

STATUS REGISTER

Note:

The C and DC bits operate as a borrow and

digit borrow bit respectively, in subtraction.

U-0

R/W-x

—

—N

bit 7

bit 0

bit 7-5

Unimplemented: Read as '0'

bit 4

N: Negative bit

This bit is used for signed arithmetic (2’s complement). It indicates whether the result was

negative (ALU MSB = 1).

= Result was negative

= Result was positive

bit 3

OV: Overflow bit

This bit is used for signed arithmetic (2’s complement). It indicates an overflow of the

7-bit magnitude, which causes the sign bit (bit 7) to change state.

= Overflow occurred for signed arithmetic (in this arithmetic operation)

= No overflow occurred

bit 2

Z: Zero bit

= The result of an arithmetic or logic operation is zero

= The result of an arithmetic or logic operation is not zero

bit 1

DC: Digit carry/borrow bit

For ADDWF, ADDLW, SUBLW, and SUBWF instructions

= A carry-out from the 4th low order bit of the result occurred

= No carry-out from the 4th low order bit of the result

Note:

For borrow, the polarity is reversed. A subtraction is executed by adding the two’s

complement of the second operand. For rotate (RRF, RLF) instructions, this bit is

loaded with either the bit 4 or bit 3 of the source register.

bit 0

C: Carry/borrow bit

For ADDWF, ADDLW, SUBLW, and SUBWF instructions

= A carry-out from the Most Significant bit of the result occurred

= No carry-out from the Most Significant bit of the result occurred

Note:

For borrow, the polarity is reversed. A subtraction is executed by adding the two’s

complement of the second operand. For rotate (RRF, RLF) instructions, this bit is

loaded with either the high or low order bit of the source register.

Legend:

R = Readable bit

W = Writable bit

U = Unimplemented bit, read as ‘0’

- n = Value at POR

‘1’ = Bit is set

‘0’ = Bit is cleared

x = Bit is unknown

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式